Table of Contents
Advertisement
Figure 42: Sample Channelization of OC12 PIC (non IQ and IQE)
Figure 42 on page 435 shows five T3 channels configured on the Channelized OC12
PIC. You can configure seven additional T3 channels. For more information about
configuring Channelized OC12 PICs, see "Configuring Channelized OC12 Interfaces"
on page 454.
Configuring Channelized OC12/STM4 IQ and IQE Interfaces (SONET Mode)
This section describes how to configure channelized OC12/STM4 IQ and IQE
interfaces, discussing the following topics:
Configuring an OC12/STM4 Interface
You can configure one OC12 interface on a one-port Channelized OC12/STM4 IQ or
IQE PIC. On a 4-port OC12/STM4 IQ or IQE PIC, you can configure one OC12 interface
per port. To configure an OC12 interface, include the
statements at the
This configuration creates interface
NOTE: Class-of-service (CoS) rules cannot be applied to an individual channel
configured on channelized IQ and IQE interfaces. You can only apply CoS rules to
the aggregate bit streams.
Configuring T3 Interfaces
To configure a T3 interface on an OC12 PIC, include the
interface-type
specifying the
Configuring an OC12/STM4 Interface on page 435
Configuring T3 Interfaces on page 435
Configuring OC3 Interfaces on page 437
Configuring T1 Interfaces on COC12 IQ and IQE Interfaces on page 438
Configuring NxDS0 Interfaces on page 439
Configuring Fractional T1 Interfaces on page 442
[edit interfaces coc12-fpc/pic/port]
[edit interfaces coc12-fpc/pic/port]
no-partition interface-type so;
statements at the
coc1
interface type:
[edit interfaces coc12-fpc/pic/port]
partition partition-number oc-slice oc-slice-range interface-type coc1;
Configuring Channelized OC12/STM4 IQ and IQE Interfaces (SONET Mode)
Chapter 19: Configuring Channelized OC12/STM4 Interfaces
no-partition
hierarchy level:
.
so-fpc/pic/port
[edit interfaces coc12-fpc/pic/port]
and
interface-type
partition
,
oc-slice
, and
hierarchy level,
435
Advertisement
Table of Contents
