Binding Vlan Ids To Logical Interfaces; Binding Vlan Ids To Logical Interfaces Overview; Binding A Vlan Id To A Logical Interface - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide
For information about binding VLAN IDs to logical interfaces, see "Binding VLAN IDs
to Logical Interfaces" on page 624. For information about configuring dual VLAN tags
using the
Example: Configuring Mixed Tagging to Support Untagged Packets
The following example configures untagged packets to be mapped to logical unit
number 0:

Binding VLAN IDs to Logical Interfaces

The following sections describe how to configure logical interfaces to receive and
forward VLAN-tagged frames:

Binding VLAN IDs to Logical Interfaces Overview

To configure a logical interface to receive and forward VLAN-tagged frames, you
must bind a VLAN ID, a range of VLAN IDs, or a list of VLAN IDs to the logical
interface. Table 56 on page 625 lists the configuration statements you use to bind
VLAN IDs to logical interfaces, organized by scope of the VLAN IDs used to match
incoming packets:
624
Binding VLAN IDs to Logical Interfaces
}
}
vlan-tag statement, see "Stacking a VLAN Tag" on page 673.
[edit interfaces ge-0/2/0]
flexible-vlan-tagging;
native-vlan-id 232;
unit 0 {
vlan-id 232;
family inet {
address 10.66.1.2/30;
}
}
unit 1 {
vlan-tags outer 0x8100.222 inner 0x8100.221;
family inet {
address 10.66.1.2/30;
}
}
Binding VLAN IDs to Logical Interfaces Overview on page 624
Binding a VLAN ID to a Logical Interface on page 625
Binding a Range of VLAN IDs to a Logical Interface on page 626
Binding a List of VLAN IDs to a Logical Interface on page 627