Bytes - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide

bytes

bytes {
Syntax
}
Hierarchy Level [edit interfaces interface-name sonet-options]
Statement introduced before JUNOS Release 7.4.
Release Information
Set values in some SONET/SDH header bytes.
Description
c2 value
Options
e1-quiet value
f1 value
s1 value
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
1012
bytes
c2 value;
e1-quiet value;
f1 value;
f2 value;
s1 value;
z3 value;
z4 value;
—Path signal label SONET/SDH overhead byte. SONET/SDH frames use the
C2 byte to indicate the contents of the payload inside the frame. SONET/SDH
interfaces use the C2 byte to indicate whether the payload is scrambled.
Range: 0 through 255
Default: 0xCF
—Default idle byte sent on the orderwire SONET/SDH overhead bytes.
The router does not support the orderwire channel, and hence sends this byte
continuously.
Range: 0 through 255
Default: 0x7F
, f2 value , z3 value , z4 value
Range: 0 through 255
Default: 0x00
—Synchronization message SONET overhead byte. This byte is normally
controlled as a side effect of the system reference clock configuration and the
state of the external clock coming from an interface if the system reference
clocks have been configured to use an external reference.
Range: 0 through 255
Default: 0xCC
Configuring SONET/SDH Header Byte Values on page 901
no-concatenate
—SONET/SDH overhead bytes.