Annex; Apply-Action-Profile - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

annex

annex (annex-a | annex-b);
Syntax
[edit interfaces interface-name shdsl-options],
Hierarchy Level
[edit interfaces interface-name sonet-options aps],
[edit logical-systems logical-system-name interfaces interface-name shdsl-options]
Statement introduced in JUNOS Release 7.4.
Release Information
For J Series Services Routers only, configure the type of SHDSL annex.
Description
For M320 and M120 routers only, for Multiplex Section Protection (MSP) switching
on SDH interfaces, set
under the
annex-b
Default
annex-a
Options
annex-b
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics

apply-action-profile

Syntax apply-action-profile profile-name;
[edit protocols oam ethernet link-fault-management interface]
Hierarchy Level
Statement introduced in JUNOS Release 8.5.
Release Information
Apply the specified action profile to the interface for link-fault management.
Description
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
annex-b
[edit interfaces so-fpc/pic/port sonet-options aps]
—Use for North American SHDSL network implementations.
—Use for European SHDSL network implementations.
ATM-over-SHDSL Overview on page 369
Applying an Action Profile on page 781
Chapter 62: Summary of Interface Configuration Statements
. You must also configure the working protection circuit
hierarchy level.
975
annex