Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 1174

JUNOS 10.1 Network Interfaces Configuration Guide
flexible-frame-relay
frame-relay
frame-relay-ccc
frame-relay-port-ccc
frame-relay-tcc
frame-relay-ether-type
frame-relay-ether-type-tcc
extended-frame-relay-ether-type-tcc
multilink-frame-relay-uni-nni
ppp
ppp-ccc
ppp-tcc
vlan-ccc
vlan-vci-ccc
vlan-vpls
1104
encapsulation (Physical Interface)
—For IQ interfaces only, use flexible Frame Relay encapsulation
when you want to configure multiple per-unit Frame Relay encapsulations. This
encapsulation type allows you to configure any combination of TCC, CCC, and
standard Frame Relay encapsulations on a single physical port. Also, each logical
interface can have any DLCI value from 1 through 1022.
—Use Frame Relay encapsulation.
—Use Frame Relay encapsulation on CCC circuits.
—Use Frame Relay port CCC encapsulation to transparently carry
all the DLCIs between two customer edge (CE) routers without explicitly
configuring each DLCI on the two provider edge (PE) routers with Frame Relay
transport. When you use this encapsulation type, you can configure the
only.
—Use Frame Relay encapsulation on TCC circuits to connect unlike
media.
—Use Frame Relay ether type encapsulation for compatibility
with Cisco Frame Relay.
—Use Frame Relay ether type TCC for Cisco-compatible
Frame Relay on TCC circuits to connect unlike media.
Cisco-compatible Frame Relay for DLCIs 1 through 1022. This encapsulation is
used for circuits with different media on either side of the connection.
—Use MLFR UNI NNI encapsulation. This encapsulation is
used only on link services and voice services interfaces functioning as FRF.16
bundles and their constituent T1 or E1 interfaces.
—Use serial PPP encapsulation.
—Use serial PPP encapsulation on CCC circuits. When you use this
encapsulation type, you can configure the
—Use serial PPP encapsulation on TCC circuits for connecting unlike media.
When you use this encapsulation type, you can configure the
—Use Ethernet VLAN encapsulation on CCC circuits.
—Use ATM-to-Ethernet interworking encapsulation on CCC circuits. When
you use this encapsulation type, you can configure the
interfaces configured on the Ethernet interface must also have the encapsulation
type set to vlan-vci-ccc .
—Use VLAN VPLS encapsulation on Ethernet interfaces with VLAN tagging
and VPLS enabled. Interfaces with VLAN VPLS encapsulation accept packets
carrying standard TPID values only.
—Use extended Frame Relay ether type TCC for
family only.
ccc
ccc
ccc family
family only.
tcc
family only. All logical