Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 365

Table 25: ATM1 and ATM2 IQ Supported Features (continued)
Item
Cell-relay promiscuous port mode:
All cells from 0 through 65,535 of all
VPIs (0 through 255) are sent to or
received from an LSP.
Cell-relay promiscuous VPI mode: All
cells in the VCI range
0 through 65,535 of a single VPI are
sent to or received from an LSP.
Cell-relay VP shaping
Cell-relay VCI mode: All cells in a VCI
are sent to or received from an LSP.
Cell-relay VPI mode: All cells in the
VCI range (0 through maximum-vcs)
of a single VPI are sent to or received
from an LSP.
Cell-relay port mode: All cells in the
VCI range (0 through maximum-vcs)
of all VPIs (0 through 255) are sent
to or received from an LSP.
Ethernet over ATM
encapsulation:Allows ATM interfaces
to connect to devices that support
only bridged-mode protocol data
units (PDUs).
ATM1 ATM2 IQ Comments
Supported Supported For promiscuous mode, you must configure the port with
atm-ccc-cell-relay
For ATM2 IQ multiport PICs, you can configure one or more
ports in port promiscuous mode, and the other ports with
Supported Supported any ATM encapsulation.
For ATM2 IQ PICs, you can configure one or more logical
interfaces in VPI promiscuous mode, and the other logical
interfaces with any ATM encapsulation.
For ATM1 PICs, if you configure one port in port mode, all
ports on the PIC operate in port mode. Likewise if you
configure one logical interface in VPI mode, all logical
interfaces on the PIC operate in VPI mode.
See "Configuring ATM Cell-Relay Promiscuous Mode" on
page 304.
Supported Supported For ATM2 PICs, you can configure ATM CC cell relay
promiscuous mode. VP promiscuous mode allows incoming
traffic on all VCIs under the VPI to be bundled and directed
to an LSP. Port promiscuous mode allows all traffic coming
in on the entire VPI/VCI range to be forwarded to an LSP. In
both modes, traffic shaping is not permitted. The ATM2 PIC
supports traffic shaping in VP promiscuous mode and cell
relay VC mode.
Supported Supported For ATM1 PICs, nonpromiscuous cell-relay VCI, VPI, and port
modes are supported on the same PIC with ATM AAL5 PVCs
or ATM AAL5 CCC.
Supported Not For ATM2 IQ PICs, nonpromiscuous cell-relay VCI mode is
supported supported on the same PIC with ATM AAL5 PVCs or ATM
AAL5 CCC.
See "Configuring ATM Interface Encapsulation" on page 338.
Supported Not For ATM1 PICs, port mode is supported on the same PIC with
supported ATM AAL5 PVCs or ATM AAL5 CCC.
See "Configuring ATM Interface Encapsulation" on page 338.
Supported Supported See "Configuring ATM Interface Encapsulation" on page 338.
Supported Features on ATM1 and ATM2 IQ Interfaces
Chapter 13: Configuring ATM Interfaces
encapsulation.
295