Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 594

JUNOS 10.1 Network Interfaces Configuration Guide
This configuration creates interfaces
Use the same configuration to create interfaces on a channelized E1 interface by
including the
hierarchy level.
To configure channelized E1 interface properties, include the
at the
To specify options for each of the DS0 channels, include the
at the
Example: Configuring a Channelized T1 Interface as Primary Rate Interface
Configure a channelized T1 interface to operate fully as a PRI:
524
Example: Configuring a Channelized T1 Interface as Primary Rate Interface
partition 2 timeslots 11-24 interface-type pr;
}
statement and options at the
partition
[edit interfaces interface-name]
[edit interfaces interface-name]
e1-options {
fcs (16 | 32);
framing (g704 | g704-no-crc4 | unframed);
idle-cycle-flag (flags | ones);
loopback (local | remote);
start-end-flag (filler | shared);
}
[edit interfaces interface-name]
[edit interfaces interface-name]
ds0-options {
byte-encoding (nx56 | nx64);
fcs (16 | 32);
idle-cycle-flag (flags | ones);
loopback payload;
start-end-flag (filler | shared);
}
[edit interfaces]
ct1-2/0/0 {
partition 1-23 timeslots 1-23 interface-type bc;
partition 24 timeslots 24 interface-type dc;
t1-options {
line-encoding b8zs;
framing esf;
}
traceoptions {
flag q931;
flag q921;
file {
pri_trace_log;
}
}
dialer-options {
pool 1 priority 25;
ds-pim/0/port:1 through pr-pim/0/port:2
[edit interfaces ce1-pim/0/port]
e1-options
hierarchy level:
ds0-options
hierarchy level:
.
statement
statement