Init-Command-String - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide

init-command-string

init-command-string initialization-command-string;
Syntax
Hierarchy Level [edit interfaces umd0 modem-options]
Statement introduced in JUNOS Release 8.2.
Release Information
For J Series Services Routers, configure the command string used to initialize the
Description
USB modem.
When you connect the USB modem to the USB port on a Services Router, the router
applies the modem AT commands configured in the
to the initialization commands on the modem.
For example, the initialization command string
to pick up a call after 2 rings.
If you do not include the
initialization string to the modem.
Options initialization-command-string
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
1172
init-command-string
init-command-string
—Specify an initialization command string using the
following AT command values:
—Disables data compression.
%C0
&C1 —Disables reset of the modem when it loses the carrier signal.
—Enables Microcom Networking Protocol (MNP) error control mode.
&Q8
AT —Attention. Informs the modem that a command follows.
—Disables the display on the local terminal of commands issued to the modem
E0
from the local terminal.
—Enables the display of result codes.
Q0
S0=0 —Disables the auto-answer feature, whereby the modem automatically
answers calls.
—Instructs the modem to wait 45 seconds for a telecommunications
S7=45
service provider (carrier) signal before terminating the call.
V1 —Displays result codes as words.
Default:
AT S7=45 S0=0 V1 X4 &C1 E0 Q0 &Q8 %C0
Specifying a USB Modem Interface on J Series Routers on page 105
init-command-string
ATS0 = 2\n configures the USB modem
statement, the router applies the default
command