Table of Contents
Advertisement
Chapter 28
Configuring ATM Support on Circuit
Emulation PICs
ATM Support on Circuit Emulation PICs Overview
ATM Support on Circuit Emulation PICs Overview on page 539
Configuring the 12-Port Channelized T1/E1 Circuit Emulation PIC Operating
Mode on page 541
Configuring the 4-Port Channelized COC3/STM1 Circuit Emulation PIC Operating
Mode on page 542
ATM IMA Configuration Overview on page 545
Configuring ATM IMA on page 551
Configuring ATM Pseudowires on page 553
ATM OAM on page 555
Scaling on page 555
Congestion Control on page 556
QoS/Shaping on page 556
Configuring the PIC Type on page 556
Configuring Layer 2 Circuit and Layer 2 VPN Pseudowires on page 556
Supported Interface Configurations on page 556
ATM Limitations on page 557
M7i, M10i, and M40e routers with 4-port COC3/CSTM1 Circuit Emulation PIC and
12-port T1/E1 Circuit Emulation PIC support ATM over MPLS (RFC 4717) and packet
encapsulations (RFC 2684). Circuit Emulation PIC ATM configuration and behavior
is consistent with existing ATM2 PICs.
The following protocols are supported:
ATM over MPLS (RFC 4717)
ATM via dynamic labels (LDP, RSVP-TE)
ATM Support on Circuit Emulation PICs Overview
539
Advertisement
Table of Contents
