Table 32: Atm-Over-Adsl Encapsulation Types - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Table 32: ATM-over-ADSL Encapsulation Types

Configuring the ATM-over-ADSL Protocol Family
Configure the protocol family type by including the
Encapsulation Types
Physical Interface
ether-over-atm
atm-pvc
Logical Interface
atm-vc-mux
atm-nlpd
atm-cisco-nlpd
atm-snap
atm-ppp-vc-mux
atm-ppp-llc
ether-over-atm-llc
ppp-over-ether-over-atm-llc
[edit interfaces at-pim/0/port unit logical-unit-number]
family family;
Chapter 14: Configuring ATM-over-ADSL Interfaces
Comments
Ethernet over ATM encapsulation.
Use this type of encapsulation for interfaces that carry
IPv4 traffic.
ATM permanent virtual circuits (PVCs).
Use ATM VC multiplex encapsulation.
You can only configure the inet
type of encapsulation.
Use ATM network layer protocol ID (NLPD) encapsulation.
You can only configure the
inet
type of encapsulation.
Use Cisco NLPD encapsulation.
You can only configure the inet
type of encapsulation.
Use ATM subnetwork attachment point (SNAP)
encapsulation.
Use PPP over ATM AAL5 multiplex encapsulation.
Use ATM PPP over AAL5 logical link control (LLC)
encapsulation.
Use Ethernet over LLC encapsulation for interfaces that
carry IPv4 traffic.
You cannot configure multipoint interfaces if you use this
type of encapsulation.
Use PPP over Ethernet over ATM LLC encapsulation.
You cannot configure the interface address when you
use this encapsulation type. Instead, you configure the
interface address on the PPP interface.
statement:
family
Configuring the ATM-over-ADSL Protocol Family
family when you use this
family when you use this
family when you use this
367