Examples: Configuring Switching Cross-Connects - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

The ATM2 OC48 PIC does not support the encapsulation type
The encapsulation type
to configure any other interface protocol family are rejected.
Configuring the ATM-to-Ethernet Interworking Protocol Family
Configure the ATM logical interface protocol family by including the
and specifying the
logical-unit-number]
Configuring the ATM-to-Ethernet Interworking Logical Interface VPI
Configure the ATM logical interface virtual path identifier by including the
statement at the
VPI 0 is reserved, and must not be used.
It is the administrator s responsibility to ensure the outer VLAN tag and VPI match
and the inner VLAN tags fall within the VCI range of the VPI.
Once a VPI is used in an ATM-to-Ethernet interworking cross-connect, it cannot be
used with any other logical interface, even if the
range for the cross-connect.
Configuring the ATM-to-Ethernet Interworking Logical Interface VCI
Configure the ATM logical interface virtual channel identifier range by including the
vci-range
interfaces interface-name unit logical-unit-number]
Do not use VCIs 0 through 31, which are reserved for ATM management purposes
by convention.

Examples: Configuring Switching Cross-Connects

vlan-vci-ccc
option at the
ccc
hierarchy level:
[edit interfaces interface-name unit logical-unit-number]
family ccc;
[edit interfaces interface-name unit logical-unit-number]
[edit interfaces interface-name unit logical-unit-number]
vpi virtual-path-identifier;
statement and specifying the starting VCI and ending VCI at the
[edit interfaces interface-name unit logical-unit-number]
vci-range start start-vci end end-vci;
Example: Configuring a CCC over Frame Relay Encapsulated Interface on page 240
Example: Configuring a TCC on page 240
Example: Configuring CCC over Aggregated Ethernet on page 242
Example: Configuring a Remote LSP CCC over Aggregated Ethernet on page 244
Example: Configuring ATM-to-Ethernet Interworking on page 246
Chapter 6: Configuring Circuit and Translational Cross-Connects
only supports the ccc
[edit interfaces interface-name unit
value falls outside the VCI
vpi.vci
hierarchy level:
Examples: Configuring Switching Cross-Connects
.
vlan-vci-ccc
protocol family. Attempts
statement
family
vpi
hierarchy level:
[edit
239