Configuring Point-To-Point Protocol Over Ethernet - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Chapter 57
Configuring Point-to-Point Protocol over
Ethernet
PPPoE Overview on page 824
Understanding PPPoE Service Name Tables on page 827
Configuring PPPoE on page 830
Disabling the Sending of PPPoE Keepalive Messages on page 837
Configuring PPPoE Service Name Tables on page 837
Creating a Service Name Table on page 838
Configuring the Action Taken When the Client Request Includes an Empty Service
Name Tag on page 839
Assigning a Service to a Service Name Table and Configuring the Action Taken
When the Client Request Includes a Non-zero Service Name Tag on page 839
Assigning an ACI/ARI Pair to a Service Name and Configuring the Action Taken
When the Client Request Includes ACI/ARI Information on page 840
Assigning a Service Name Table to a PPPoE Underlying Interface on page 841
Example: Configuring a PPPoE Service Name Table on page 841
Tracing PPPoE Operations on page 844
Troubleshooting PPPoE Service Name Tables on page 847
Verifying a PPPoE Configuration on page 848
823