Table 30: Atm Logical Interface Encapsulation Types - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Table 30: ATM Logical Interface Encapsulation Types

Encapsulation Types
ATM CCC cell relay
ATM CCC VC multiplex
ATM network layer protocol identifier
(NLPID)
ATM SNAP
ATM SNAP encapsulation on
translational cross-connect (TCC)
circuits
ATM VC multiplex
ATM VC multiplex on TCC circuits
Cell-relay accumulation mode (CAM)
Cisco ATM NLPID
Ethernet over ATM
Ethernet VPLS over ATM
Multilink PPP over AAL5 LLC
Comments
This encapsulation type connects two remote virtual circuits or ATM physical interfaces
with an LSP.
This encapsulation type carries traffic in ATM cells.
When you use this encapsulation type, you can configure the
This encapsulation type is for CCC circuits.
When you use this encapsulation type, you can configure the
When you use this encapsulation type, you can configure the
When you use this encapsulation type, you can configure the
When you use this encapsulation type, you can configure the
When you use this encapsulation type, you can configure the
In this mode, the incoming 1 to 8 cells are packaged into a single packet and forwarded
to the LSP. To configure CAM, include the
[edit chassis fpc slot-number pic pic-number]
This encapsulation type is for ATM1 interfaces only.
For more information about CAM, see the JUNOS System Basics Configuration Guide.
When you use this encapsulation type, you can configure the
This encapsulation type is for interfaces that carry IPv4 traffic.
When you use this encapsulation type, you cannot configure point-to-multipoint
interfaces.
This encapsulation type enables a VPLS instance to support bridging between Ethernet
interfaces and ATM interfaces, as described in RFC 2684.
Use this encapsulation type to support IEEE 802.1p classification binding on ATM VCs.
This encapsulation type is for ATM2 IQ interfaces only.
When you use this encapsulation type, you cannot configure point-to-multipoint
interfaces.
This encapsulation type is for ATM2 IQ interfaces only.
When you use this encapsulation type, your router must be equipped with a Link
Services or Voice Services PIC.
Chapter 13: Configuring ATM Interfaces
ccc
ccc
inet
tcc
inet
tcc
atm-cell-relay-accumulation
hierarchy level.
inet
Configuring ATM Interface Encapsulation
family only.
family only.
family only.
family only.
family only.
family only.
statement at the
family only.
339