Configuring E1 or Channelized E1 Interfaces
To configure E1 or channelized E1 interfaces, include the
statements at the
or
This configuration creates the interfaces
ce1-fpc/pic/port:channel
NOTE: Class-of-service (CoS) rules cannot be applied to an individual channel
configured on channelized IQE interfaces. You can only apply CoS rules to the
aggregate bit streams.
Example: Configuring E1 or Channelized CE1 Interfaces
Configure E1 or channelized CE1 interfaces, using partition 3 and partition 4:
This configuration creates interfaces
Configuring NxDS0 Interfaces on Channelized OC12/STM4 IQE PICs
Configure channelized NxDS0 interfaces on the channelized E1 interface by including
the
ce1-fpc/pic/port:channel]
This configuration creates the interface
[edit interfaces]
cau4-0/2/0:1 {
partition 1 interface-type e3;
}
e3-0/2/0:1:1;
[edit interfaces cau4-fpc/pic/port]
interface type:
ce1
[edit interfaces]
cau4-fpc/pic/port {
partition partition-number interface-type e1;
}
cau4-fpc/pic/port {
partition partition-number interface-type ce1;
}
.
[edit interfaces]
cau4-0/2/0:1 {
partition 3 interface-type e1;
}
cau4-0/2/0:1 {
partition 4 interface-type ce1;
}
partition
,
timeslots
, and
hierarchy level, specifying the
[edit interfaces ce1-fpc/pic/port:channel:channel]
partition partition-number timeslots time-slot-range interface-type ds;
Configuring Channelized OC12/STM4 IQE Interfaces (SDH Mode)
Chapter 19: Configuring Channelized OC12/STM4 Interfaces
hierarchy level, specifying the
e1-fpc/pic/port:channel
and
e1-0/2/0:1:3
interface-type
statements at the
ds-fpc/pic/port:channel
and
partition
interface-type
and
.
ce1-0/2/0:1:4
[edit interfaces
interface type:
ds
.
447
e1