Examples: Configuring Channelized Ds3-To-Ds0 Interfaces; Figure 48: Sample Channelization Of Ds3 Iq Or Iqe Pic - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Figure 48: Sample Channelization of DS3 IQ or IQE PIC

Examples: Configuring Channelized DS3-to-DS0 Interfaces

The following configuration is sufficient to get the channelized DS3-to-DS0 interface
up and running. The T3 interface can be divided into 28 channels, each at T1 line
rate. DS3 channels can use the following encapsulation types for their logical
interfaces:
For more information, see "Configuring a Point-to-Point Frame Relay Connection"
on page 388.
[edit interfaces]
ct3-1/1/0 {
description "CT3 to CT1 and CT3 to T1.";
t3-options {
loopback remote;
looptiming;
}
partition 1 interface-type ct1; # ct1-1/1/0:1.
partition 2-28 interface-type t1; # t1-1/1/0:[2-28]
}
ct1-1/1/0:1 {
description "case (a) CT1s to NxDSOs.";
t1-options {
bert-algorithm all-ones-repeating;
framing sf;
line-encoding ami;
}
partition 1 timeslots 2 - 10 interface-type ds0; # ds-1/1/0:1:1, channel group with
10 DS0s
partition 2 timeslots 11- 23 interface-type ds0; # ds-1/1/0:1:2, channel group with
13 DS0s
...
}
PPP, PPP CCC, and PPP TCC
Frame Relay, Frame Relay CCC, and Frame Relay TCC
Cisco HDLC, Cisco HDLC CCC, and Cisco HDLC TCC
Examples: Configuring Channelized DS3-to-DS0 Interfaces
Chapter 22: Configuring Channelized T3 Interfaces
497