Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 740

JUNOS 10.1 Network Interfaces Configuration Guide
On Ethernet IQ, IQ2, and IQ2-E interfaces; on MX Series router Gigabit Ethernet,
Tri-Rate Ethernet copper, and 10-Gigabit Ethernet interfaces; and on aggregated
Ethernet interfaces using Gigabit Ethernet IQ2 and IQ2-E or 10-Gigabit Ethernet PICs
on MX Series routers, to configure the inner TPID, include the
statement:
You can include this statement at the following hierarchy levels:
For the inner VLAN ID, include the
the
For aggregated Ethernet interfaces using Gigabit Ethernet IQ interfaces, include the
tag-protocol-id
statement:
You can include these statements at the following hierarchy levels:
670
Configuring Inner and Outer TPIDs and VLAN IDs
inner-tag-protocol-id tpid;
[edit interfaces interface-name unit logical-unit-number input-vlan-map]
[edit interfaces interface-name unit logical-unit-number output-vlan-map]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number input-vlan-map]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number output-vlan-map]
statement. For the outer VLAN ID, include the
tag-protocol-id
input-vlan-map {
(pop | pop-pop | pop-swap | push | push-push | swap | swap-push | swap-swap);
inner-tag-protocol-id tpid;
inner-vlan-id number;
tag-protocol-id tpid;
vlan-id number;
}
output-vlan-map {
(pop | pop-pop | pop-swap | push | push-push | swap | swap-push | swap-swap);
inner-tag-protocol-id tpid;
inner-vlan-id number;
tag-protocol-id tpid;
vlan-id number;
}
statement for the outer TPID. For the outer VLAN ID, include the
input-vlan-map {
(pop | push | swap);
tag-protocol-id tpid;
vlan-id number;
}
output-vlan-map {
(pop | push | swap);
tag-protocol-id tpid;
vlan-id number;
}
[edit interfaces interface-name unit logical-unit-number]
inner-vlan-id statement. For the outer TPID, include
inner-tag-protocol-id
statement:
vlan-id
vlan-id