Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 441

For more information about configuring ATM VPI options, see "Configuring the
Maximum Number of ATM1 VCs on a VP" on page 307.
To configure logical interface properties, include the
statement, and
You can include these statements at the following hierarchy levels:
Configuring ATM Mode on the PIM
The J Series routers with an SHDSL PIM installed support the 2-port, two-wire mode
(Annex A or Annex B). You can configure only one mode on each 2-port SHDSL PIM.
NOTE: G.SHDSL interfaces on a J Series router only support 2-port, two-wire mode.
This is enabled by default. The 1-port, 4-wire mode is not supported.
The two-wire mode supports autodetection of the line rate or fixed line rate and
network speeds from 192 Kbps to 2.3 Kbps in 64-Kbps increments.
For information about configuring Annex A or Annex B, see "Configuring SHDSL
Operating Mode on an ATM Physical Interface" on page 372.
To configure the ATM mode for SHDSL, include the
chassis fpc fpc-number pic 0 shdsl]
The default is 2-wire (two-port ATM) mode. To set the default explicitly, specify the
2-port-atm
}
}
statement:
vci
unit logical-unit-number {
encapsulation type;
family inet {
vci vpi-identifier.vci-identifier;
}
}
[edit interfaces interface-name unit logical-unit-number]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number]
[edit chassis]
fpc fpc-number {
pic 0 {
shdsl {
pic-mode (1-port-atm | 2-port-atm);
}
}
}
option. For 4-wire (single-port ATM) mode, specify the
Chapter 15: Configuring ATM-over-SHDSL Interfaces
encapsulation
pic-mode
hierarchy level:
Configuring ATM Mode on the PIM
statement, family
statement at the
[edit
option.
1-port-atm
371