Configuring Channelized Oc48/Stm16 Iqe Interfaces (Sdh Mode); Configuring A Channelized Oc48/Stm16 Iqe Pic For Sdh Mode; Configuring Clear Channel Stm1 And Stm4 Interfaces; Configuring Channelized Au-4 Interfaces - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

For a full configuration example, see the JUNOS Feature Guide.

Configuring Channelized OC48/STM16 IQE Interfaces (SDH Mode)

The Channelized OC48 IQE PIC configured for SDH mode creates a single channelized
STM16 interface. You can configure the STM16 interface using the
at the
following OC slices:
This section describes how to configure the following channelized OC48 IQE interfaces
on a Channelized OC48 IQE PIC configured in SDH mode:

Configuring a Channelized OC48/STM16 IQE PIC for SDH Mode

To configure a Channelized OC48/STM16 IQE PIC to operate in SDH mode, include
the
This configuration creates interface
For more information, see the JUNOS System Basics Configuration Guide.
[edit interfaces ct1-0/0/0:1:2]
partition 1 timeslots 1-10 interface-type ds;
partition 2 timeslots 12-15 interface-type ds;
[edit interfaces cstm16-fpc/pic/port]
16 channelized AU-4 interfaces or a path layer with 4 STM4 or 16 STM1 interfaces.
16 channelized AU-4 interfaces, each partitioned to 3 clear channel E3 interfaces
or 63 CE1 or E1 (ITU-T or KLM) interfaces. Combination of E1, CE1 and E3 are
not supported in a single cau4.
16 channelized AU-4 interfaces, each partitioned to 63 CE1 (ITU-T or KLM)
interfaces each partitioned to 31 NxDS0 interfaces
Configuring a Channelized OC48/STM16 IQE PIC for SDH Mode on page 423
Configuring Clear Channel STM1 and STM4 Interfaces on page 424
Configuring Channelized AU-4 Interfaces on page 424
Configuring E3 Interfaces on page 425
Configuring E1 or Channelized E1 Interfaces on page 426
Configuring NxDS0 IQE Interfaces on page 426
Configuring T3 or Channelized T3 Interfaces on page 427
Configuring T1 or Channelized T1 Interfaces on page 428
statement at the
framing sdh
[edit chassis ]
fpc 0 {
pic 2 {
framing sdh;
}
}
}
Configuring Channelized OC48/STM16 IQE Interfaces (SDH Mode)
Chapter 18: Configuring Channelized OC48/STM16 IQE Interfaces
hierarchy level to partition it into the
[edit chassis fpc fpc/pic/port]
.
cstm16-0/2/0
statement
partition
hierarchy level:
423