Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 323

The following example is a sequence of
session with a T1600 router in a routing matrix. In the example, the T1600 router,
which is also called the line-card chassis (LCC), is known by the IP host name
host-sfc-0-lcc-2 and contains redundant Routing Engines.
This T1600 router is connected to the routing matrix through a connection in the
TXP-SIB-F13 in slot 2 of the SCC. The commands display information about the
management Ethernet interface and both internal Ethernet interfaces configured on
the Routing Engine to which you are currently logged in:
NOTE: In a routing matrix, the
the current router only. If you are logged in to the TX Matrix Plus router, the
interfaces command output does not include information about any of the attached
T1600 routers. To display interface information about a specific T1600 router in the
routing matrix, you must first log in to that router.
The previous example shows a CLI session with the TX Matrix Plus router. To display
interface information about the T1600 router known as
request routing-engine login
user@host-sfc-0> request routing-engine login lcc 2
--- JUNOS 9.6I built 2009-06-22 18:13:04 UTC
% cli
warning: This chassis is a Line Card Chassis (LCC) in a multichassis system.
warning: Use of interactive commands should be limited to debugging.
warning: Normal CLI access is provided by the Switch Fabric Chassis (SFC).
warning: Please logout and log into the SFC to use CLI.
user@host-sfc-0-lcc-2> show interfaces em0 terse
Interface Admin Link Proto
em0 up
em0.0 up
user@host-sfc-0-lcc-2> show interfaces bcm0 terse
Interface Admin Link Proto
bcm0 up
bcm0.0 up
user@host-sfc-0-lcc-2> show interfaces em1 terse
Interface Admin Link Proto
em1 up
em1.0 up
Displaying Internal Ethernet Interfaces for a Routing Matrix with a TX Matrix Plus Router
Chapter 8: Displaying the Internal Ethernet Interface
show interfaces
show interfaces command displays information about
command to log in to that LCC.
Local
up
up inet 192.168.35.117/24
Local
up
up inet 10.1.0.5/8
129.0.0.5/2
inet6 fe80::201:ff:fe01:5/64
fec0::a:1:0:5/64
tnp 0x1000005
Local
up
up inet 10.1.0.5/8
129.0.0.5/2
inet6 fe80::201:1ff:fe01:5/64
fec0::a:1:0:5/64
tnp 0x1000005
commands issued in a CLI
show
, first use the
host-sfc-0-lcc-2
Remote
Remote
Remote
253