Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 361

To configure ATM1 logical interface properties, include the following statements:
ATM1 Logical
Configuration Hierarchy
z3 value ;
z4 value;
}
loopback (local | remote);
(payload-scrambler | no-payload-scrambler);
rfc-2615;
trigger {
defect ignore {
hold-time up milliseconds down milliseconds;
}
}
(z0-increment | no-z0-increment);
}
t3-options {
atm-encapsulation (direct | plcp);
buildout feet;
(cbit-parity | no-cbit-parity);
loopback (local | payload | remote);
(payload-scrambler | no-payload-scrambler);
}
allow-any-vci;
multicast-vci vpi-identifier.vci-identifier;
oam-liveness {
up-count cells;
down-count cells;
}
oam-period (disable | seconds);
shaping {
(cbr rate | vbr peak rate sustained rate burst length);
queue-length number;
}
vci vpi-identifier.vci-identifier;
vpi vpi-identifier;
family inet {
address address {
multipoint-destination address {
inverse-arp;
oam-liveness {
up-count cells;
down-count cells;
}
oam-period (disable | seconds);
shaping {
(cbr rate | vbr peak rate sustained rate burst length);
queue-length number;
}
vci vpi-identifier.vci-identifier;
}
}
}
ATM1 Physical and Logical Configuration Statement Hierarchies
Chapter 13: Configuring ATM Interfaces
291