Configuring Vlan Encapsulation - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

In the example configuration above,
and
and
ge-1/1/1.20

Configuring VLAN Encapsulation

Gigabit Ethernet IQ, Gigabit Ethernet PICs with small form-factor pluggable optics
(SFPs), and MX Series router Gigabit Ethernet, Tri-Rate Ethernet copper, and 10-Gigabit
Ethernet interfaces with VLAN tagging enabled can use flexible Ethernet services,
VLAN CCC, or VLAN virtual private LAN service (VPLS) encapsulation.
Aggregated Ethernet interfaces configured for VPLS can use Ethernet VPLS or VLAN
VPLS.
To configure the encapsulation on a Gigabit Ethernet IQ or Gigabit Ethernet physical
interface, include the
hierarchy level, specifying
To configure the encapsulation on an aggregated Ethernet interface, include the
encapsulation
specifying
Ethernet interfaces in VLAN mode can have multiple logical interfaces. In CCC and
VPLS modes, VLAN IDs from 1 through 511 are reserved for normal VLANs, and
VLAN IDs 512 through 4094 are reserved for CCC or VPLS VLANs. For 4-port Fast
Ethernet interfaces, you can use VLAN IDs 512 through 1024 for CCC or VPLS VLANs.
For encapsulation type
In general, you configure an interface s encapsulation at the
interface-name]
flexible Ethernet services, Ethernet VLAN CCC and VLAN VPLS, you can also configure
the encapsulation type that is used inside the VLAN circuit itself. To do this, include
the
You can include this statement at the following hierarchy levels:
encapsulation vlan-ccc;
vlan-tags outer 200 inner-list [50 60 80 90 100];
}
}
ge-1/1/1 supports mixed tagging. The single-tag logical interfaces
each bundle lists of VLAN IDs. The dual-tag logical interface
ge-1/1/1.20
bundles lists of inner VLAN IDs.
encapsulation
flexible-ethernet-services
[edit interfaces interface-name]
encapsulation (flexible-ethernet-services | vlan-ccc | vlan-vpls);
statement at the
flexible-ethernet-services
[edit interfaces interface-name]
encapsulation (flexible-ethernet-services | ethernet-vpls | vlan-vpls);
flexible-ethernet-services
hierarchy level. However, for some encapsulation types, including
statement:
encapsulation
encapsulation (vlan-ccc | vlan-tcc | vlan-vpls);
[edit interfaces interface-name unit logical-unit-number]
Chapter 34: Configuring 802.1Q VLANs
supports single-tag logical interfaces,
ge-1/1/0
statement at the
[edit interfaces interface-name]
, vlan-ccc
[edit interfaces interface-name]
, ethernet-vpls , or vlan-vpls
, all VLAN IDs are valid.
Configuring VLAN Encapsulation
ge-1/1/0.10
, or vlan-vpls :
hierarchy level,
:
[edit interfaces
629