Configuring The Action Taken When The Client Request Includes An Empty Service Name Tag; Assigning A Service To A Service Name Table And Configuring The Action Taken When The Client Request Includes A Non-Zero Service Name Tag - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Related Topics
Configuring the Action Taken When the Client Request Includes an Empty Service
Name Tag
You can configure the action taken by the PPPoE underlying interface when it receives
a PADI packet that includes a zero-length (empty) service name tag. The empty
service is present by default in every PPPoE service name table.
To indicate that it can service the client request, the interface returns a PADO packet
in response to the PADI. By default, the interface immediately responds to the request;
this is the terminate action. You can specify that the PADI packet is ignored (dropped),
or you can set a delay between receipt of the PADI packet and transmission of the
PADO packet.
(Optional) To configure the action taken for the empty service in response to a PADI
packet from a PPPoE client, specify the action:
Related Topics
Assigning a Service to a Service Name Table and Configuring the Action Taken
When the Client Request Includes a Non-zero Service Name Tag
You can specify up to 16 service names for each PPPoE service name table. You can
optionally configure the action taken by the PPPoE underlying interface when it
receives a PADI packet that includes a service name (service name tag).
To indicate that it can service the client request, the interface returns a PADO packet
in response to the PADI. By default, the interface immediately responds to the request;
this is the terminate action. You can specify that the PADI packet is ignored (dropped),
or you can set a delay between receipt of the PADI packet and transmission of the
PADO packet.
(Optional) To configure a service for the service name table, do one of the following:

Configuring the Action Taken When the Client Request Includes an Empty Service Name Tag

Configuring PPPoE Service Name Tables on page 837
[edit protocols pppoe service-name-tables table1]
user@host# set empty-service drop
Configuring PPPoE Service Name Tables on page 837
Assign a service name to the table. The terminate action is applied to the service
by default.
[edit protocols pppoe service-name-tables table1]
user@host# set service gold-service
Specify the action taken for a service in response to a PADI packet from a PPPoE
client.
[edit protocols pppoe service-name-tables table1]
user@host# set service gold-service delay 25
Chapter 57: Configuring Point-to-Point Protocol over Ethernet
839