Table 80: Handling Oversubscription On 10-Port 10-Gigabit Ose Pics - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Network interfaces configuration
Table of Contents

Advertisement

JUNOS 10.1 Network Interfaces Configuration Guide
To configure the PIC in line rate mode, include the
[edit chassis set fpc fpc-number pic pic-number]
To return to the default oversubscribed Ethernet mode, delete the
statement at the
NOTE: When the mode of operation of a PIC is changed, the PIC is taken offline and
then brought back online immediately.
Example: Handling Oversubscription on 10-port 10-Gigabit Oversubscribed Ethernet
PIC
Table 80 on page 812 lists the scenarios of handling oversubscription on the 10-port
10-Gigabit Oversubscribed Ethernet (OSE) PIC for different combinations of port
groups and active ports on the PIC.

Table 80: Handling Oversubscription on 10-port 10-Gigabit OSE PICs

Number of Port
Groups with Two
Active Ports (A)
0
0
0
1
1
3
812
Example: Handling Oversubscription on 10-port 10-Gigabit Oversubscribed Ethernet PIC
Line Rate Mode: In this mode, only five alternate ports (ports 0, 2, 4, 6, and 8)
are enabled. The PIC operates in line rate mode at 50 Gbps.
[edit chassis]
set fpc fpc-number pic pic-number linerate-mode;
[edit chassis fpc fpc-number pic pic-number]
Total Number of
Number of Port
Ports Used on
Groups with One
PIC (C = Ax2 +
Active Port (B)
B)
1
1
2
2
5
5
0
2
4
6
0
6
linerate-mode
hierarchy level:
Status of Oversubscription and Throughput
Oversubscription is not active. Each port will receive
10 Gbps throughput.
Oversubscription is not active. Each port will receive
10 Gbps throughput.
Oversubscription is not active. Each port will receive
10 Gbps throughput.
Oversubscription is active. Each port will receive 5
Gbps throughput (with default shaper configuration).
Oversubscription is active for the port group that has
two active ports. Each port in this port group will
receive 5 Gbps throughput (with default shaper
configuration).
For the remaining four ports, oversubscription is not
active. Each port will receive 10 Gbps throughput.
Oversubscription is active. Each port will receive 5
Gbps throughput (with default shaper configuration).
statement at the
linerate-mode
hierarchy level.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junos 10.1

Table of Contents