Verifying A Pppoe Configuration - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide
interface is increasing, but the number of PADO packets sent remains at zero. The
following sample output shows a PADI count of 100 and a PADO count of 0.
user@host> show pppoe statistics ge-2/0/3.1
Active PPPoE sessions: 0
When you believe a misconfiguration exists, use the
on the underlying interface to determine which service name is being requested by
the PPPoE client. The following sample output shows that the client is requesting
Service1 in the service name tag.
user@host> monitor traffic interface ge-2/0/3.1 print-hex print-ascii
[TAG-0x120 UTF8] [Vendor-Specific UTF8]
You can then use the
you have misspelled the name of the service or perhaps not configured the service
at all.
Typical misconfigurations appear in the service name table configurations.
Cause
Use the appropriate statements to correct the misconfiguration.
Solution
Related Topics

Verifying a PPPoE Configuration

You can use show commands to display and verify the PPPoE configuration.
Purpose
848
Verifying a PPPoE Configuration
PacketType
PADI
PADO
PADR
PADS
PADT
Service name error
AC system error
Generic error
Malformed packets
Unknown packets
Listening on ge-2/0/3.1, capture size 96 bytes
11:49:41.436682 In PPPoE PADI [Service-Name "Service1"] [Host-Uniq UTF8]
0x0000 ffff ffff ffff 0090 1a42 0ac1 8100 029a
0x0010 8863 1109 0000 00c9 0101 0008 5365 7276
0x0020 6963 6531 0103 0004 1200 9c43 0120 0002
0x0030 044a 0105 00ab 0000 0de9 0124 783a 3132
0x0040 3030 3963
show pppoe service-name-tables
Configuring PPPoE Service Name Tables on page 837
show pppoe service-name-tables
show pppoe statistics
show pppoe underlying-interfaces
Sent Received
0 100
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
monitor traffic interface
.........B......
.c..........Serv
ice1.......C....
.J.........$x:12
009c
command to determine whether
command