Configuring Callback; Example: Configuring Dial-In And Callback - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Configuring Callback on page 886
Example: Configuring Dial-In and Callback on page 886
Configuring Dial-In
To configure the dialer interface for dial-in operation, include the
statement with options at the
hierarchy level:
[edit interfaces dln unit logical-unit-number]
dialer-options {
incoming-map {
caller (caller-id | accept-all);
}
}
}
NOTE: The incoming-map
incoming ISDN calls.
Include the option
accept-all
accept-all option for only one of the dialer interfaces associated with an ISDN physical
interface. The dialer interface with the
if the incoming call s caller ID does not match against the caller IDs configured on
other dialer interfaces.
Include the
caller caller-id
from a specific caller ID. You can configure a maximum of 15 caller IDs per dialer
interface.
The same caller ID cannot be configured on different dialer interfaces. However, you
can configure a subset of the caller ID configured on another dialer interface. For
example, you can configure the caller IDs 14085551515, 4085551515, and 5551515
on different dialer interfaces.
Disabling Dial-In
When dial-in is configured on the Services Router, incoming ISDN calls are accepted
by the Services Router. However, you can configure the Services Router to reject all
incoming ISDN calls when dial-in is configured.
To configure the Services Router to reject incoming ISDN calls, include the
statement at the
reject-incoming
[edit system processes isdn-signaling]
reject-incoming;
For more information about disabling dial-in, see the JUNOS System Basics
Configuration Guide and the JUNOS Software Interfaces and Routing Configuration
Guide.
[edit interfaces dln unit logical-unit-number dialer-options]
statement is mandatory for the router to accept any
to accept all incoming calls. You can configure the
option configured will be used only
accept-all
statement to configure the dialer interface to accept calls
[edit system processes isdn-signaling]
Configuring ISDN Logical Interface Properties
Chapter 60: Configuring ISDN Interfaces
incoming-map
hierarchy level:
885