Example: Configuring Fractional T1 Iq Interfaces; Configuring An Nxds0 Iq Interface - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

For channelized T1 IQ interfaces, the time-slot range is from 1 through 24. You can
designate any combination of time slots. To configure ranges, use hyphens. To
configure discontinuous time slots, use commas. Do not include spaces. For more
information about T1 time slots, see "Configuring Fractional T1 Time Slots" on
page 585.

Example: Configuring Fractional T1 IQ Interfaces

Configure a fractional T1 interface that uses time slots 1 through 10:
For a full configuration example, see the JUNOS Feature Guide.

Configuring an NxDS0 IQ Interface

By default, all the time slots on a channelized T3 interface are used. To configure an
NxDS0 IQ interface on a Channelized DS3 IQ or IQE PIC, perform the following tasks:
1.
NOTE: For channelized T3 interfaces, channel numbering begins with 0 (:0). For
channelized T3 IQ interfaces, channel numbering begins with 1 (:1).
2.
[edit interfaces t1-fpc/pic/port t1-options]
timeslots time-slot-range;
[edit interfaces ct3-0/0/0:1]
partition 1 interface-type t1;
[edit interfaces t1-0/0/0:1:1 t1-options]
timeslots 1-10;
Partition the channelized T3 interface into channelized T1 interfaces by including
the and
partition interface-type
hierarchy level, specifying the
[edit interfaces ct3-fpc/pic/port]
partition partition-number interface-type ct1;
This configuration creates interface
The partition number is the sublevel interface partition index and is correlated
with the channel number. For channelized T1 interfaces, the partition number
can be from 1 through 28.
The interface type is the channelized interface type or clear channel you are
creating. For channelized T3 interfaces,
Configure the number of time slots allocated to the NxDS0 IQ interface by
including the partition , timeslots
interfaces ct1-fpc/pic/port:channel]
type:
[edit interfaces ct1-fpc/pic/port:channel]
partition partition-number timeslots time-slot-range interface-type ds;
Chapter 22: Configuring Channelized T3 Interfaces
statements at the
[edit interfaces ct3-fpc/pic/port]
ct1 interface type:
ct1-fpc/pic/port:channel
can be
type ct1
, and interface-type statements at the
hierarchy level, specifying the
Configuring Channelized T3 IQ Interfaces
.
or .
t1
[edit
interface
ds
491