Creating The Maintenance Domain; Configuring The Maintenance Domain Name Format; Configuring The Maintenance Domain Level; Figure 63: Relationship Among Bridges, Maintenance Domains, Maintenance - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Figure 63: Relationship Among Bridges, Maintenance Domains, Maintenance

Associations, and MEPs

Creating the Maintenance Domain

To enable CFM on an Ethernet interface, maintenance domains, maintenance
associations, and MEPs must be created and configured.
To create a maintenance domain, include the
statement at the
level.
Give the maintenance domain a name. Names can be in one of several formats:

Configuring the Maintenance Domain Name Format

You can specify the maintenance domain name format as one of the following:.
If none is specified, the maintenance domain name is not used.
The default name format is an ASCII character string.
To configure the maintenance domain name format, include the
(character-string | none | dns | mac+2octet)
connectivity-fault-management maintenance-domain domain-name]
Chapter 43: Configuring IEEE 802.1ag OAM Connectivity-Fault Management
[edit protocols oam ethernet connectivity-fault-management]
Configuring the Maintenance Domain Name Format on page 705
Configuring the Maintenance Domain Level on page 706
A plain ASCII character string.
A domain name service (DNS) format, a MAC address plus a two-octet identifier
in the range from 0 through 65,535, or none.
A MAC address plus a two-octet identifier in the range from 0 through 65,535.
Or none.
maintenance-domain domain-name
name-format
statement at the [edit protocols oam ethernet
hierarchy level.
Creating the Maintenance Domain
hierarchy
705