Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 440

JUNOS 10.1 Network Interfaces Configuration Guide
NOTE: You can configure J Series routers with SHDSL PIMs for connections through
SHDSL only, not for direct ATM connections.
Related Topics
Configuring ATM Mode for SHDSL Overview
To configure the ATM mode for SHDSL, include the
chassis fpc fpc-number pic 0 shdsl]
For more information about configuring the ATM mode, see the JUNOS System Basics
Configuration Guide and the JUNOS Software Interfaces and Routing Configuration
Guide.
To configure SHDSL operating mode on the physical ATM interface and set the
encapsulation, include the
at the
To configure ATM virtual path identifier (VPI) options for the interface, include the
vpi
370
Configuring ATM Mode for SHDSL Overview
[edit chassis]
fpc fpc-number {
pic 0 {
shdsl {
pic-mode (1-port-atm | 2-port-atm);
}
}
}
shdsl-options
[edit interfaces at-pim/0/port]
[edit interfaces at-pim/0/port]
shdsl-options {
annex (annex-a | annex-b);
line-rate line-rate;
loopback (local remote);
snr-margin {
current margin;
snext margin;
}
encapsulation (atm-pvc | ethernet-over-atm)
}
statement at the
[edit interfaces interface-name atm-options]
[edit interfaces interface-name]
atm-options {
vpi vpi-identifier {
maximum-vcs maximum-vcs;
oam-liveness {
up-count cells;
down-count cells;
}
oam-period (disable | seconds);
pic-mode
hierarchy level:
statement and the
encapsulation
hierarchy level:
statement at the [edit
statement
hierarchy level: