Configuring Pppoe - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Network interfaces configuration
Table of Contents

Advertisement

JUNOS 10.1 Network Interfaces Configuration Guide
Related Topics

Configuring PPPoE

To configure PPPoE on a J Series Services Router, perform the following tasks:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
To configure PPPoE on an M120 or M320 Internet Router operating as an access
concentrator, perform the following tasks:
1.
2.
3.
4.
5.
6.
7.
8.
830
Configuring PPPoE
send a PADO packet to the client within the delay period configured on the
backup AC, then the backup AC sends the PADO packet after the delay period
expires.
Configuring PPPoE Service Name Tables on page 837
Example: Configuring a PPPoE Service Name Table on page 841
Configure PPPoE encapsulation for an Ethernet interface or Ethernet over ATM
encapsulation for an ATM-over-ADSL interface.
If you are configuring ATM over ADSL, configure LLC encapsulation on the logical
interface.
Specify the logical Ethernet interface or the logical ATM interface as the underlying
interface for the PPPoE session.
Configure the operational mode as client.
Identify the access concentrator by a unique name.
Optionally, specify how many seconds to wait before attempting to reconnect.
Provide a name for the type of service provided by the access concentrator.
Optionally, configure the maximum transmission unit (MTU) of the interface.
Configure the PPPoE interface address.
Configure the destination PPPoE interface address.
Optionally, configure the MTU size for the protocol family.
Optionally, disable the sending of keepalive messages on the logical interface.
Configure PPPoE encapsulation for an Ethernet interface.
Specify the logical Ethernet interface as the underlying interface for the PPPoE
session.
Optionally, configure the maximum transmission unit (MTU) of the interface.
Configure the operational mode as server.
Configure the PPPoE interface address.
Configure the destination PPPoE interface address.
Optionally, configure the MTU size for the protocol family.
Optionally, configure one or more PPPoE service name tables and the action
taken for each service in the tables.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junos 10.1

Table of Contents