Table of Contents
Advertisement
automatically configures the remainder of the load-sharing setup based on the group
name.
Example: Configuring APS Load Sharing Between Circuit Pairs
Configure APS load sharing to match the configuration shown in Figure 77 on page 926:
On Router A
On Router B
Configuring SONET Options for 10-Gigabit Ethernet Interfaces
The 10-Gigabit Ethernet IQ2 and IQ2-E PIC is supported on the M120, M320, and T
Series routers. The PIC provides one external interface running at 10 Gbps. The
interface operates in either LAN PHY or WAN PHY mode. When the external interface
is running in WAN PHY mode, it uses the WIS sublayer to transport 10-Gigabit
Ethernet frames in an OC192c SONET payload, and can interoperate with SONET
section or line level repeaters. This creates an advantage when the interface is used
for long-distance, point-to-point 10-Gigabit Ethernet links.
When the external interface is running in WAN PHY mode, you can configure specific
physical SONET options. To configure SONET options, include the
path-trace
hierarchy level:
[edit interfaces so-fpc/pic/port sonet-options aps]
paired-group group-name;
[edit interfaces so-7/0/0 sonet-options aps]
user@host# set working-circuit start
[edit interfaces so-7/0/0 sonet-options aps]
user@host# set authentication-key linsey
[edit interfaces so-7/0/0 sonet-options aps]
user@host# set paired-group "Router A-Router B"
...
[edit interfaces so-0/0/0 sonet-options aps]
user@host# set protect-circuit up
[edit interfaces so-0/0/0 sonet-options aps]
user@host# set authentication-key woolsey
[edit interfaces so-0/0/0 sonet-options aps]
user@host# set paired-group "Router A-Router B"
[edit interfaces so-1/0/0 sonet-options aps]
user@host# set working-circuit up
[edit interfaces so-1/0/0 sonet-options aps]
user@host# set authentication-key woolsey
[edit interfaces so-1/0/0 sonet-options aps]
user@host# set paired-group "Router A-Router B"
...
[edit interfaces so-6/0/0 sonet-options aps]
user@host# set protect-circuit start
[edit interfaces so-6/0/0 sonet-options aps]
user@host# set authentication-key linsey
[edit interfaces so-6/0/0 sonet-options aps]
user@host# set paired-group "Router A-Router B"
, and
statements at the
trigger
Chapter 61: Configuring SONET/SDH Interfaces
[edit interfaces interface-name sonet-options]
Configuring SONET/SDH Physical Interface Properties
loopback
,
mpls
,
927
Advertisement
Table of Contents
