Control-Signal; Copy-Tos-To-Outer-Ip-Header - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide

control-signal

control-signal (assert | de-assert | normal);
Syntax
[edit interfaces interface-name serial-options dce-options],
Hierarchy Level
[edit interfaces interface-name serial-options dte-options]
Statement introduced before JUNOS Release 7.4.
Release Information
For X.21 interfaces only, configure the to-DCE signal.
Description
Options assert
de-assert
normal
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics

copy-tos-to-outer-ip-header

copy-tos-to-outer-ip-header;
Syntax
[edit interfaces at-fpc/pic/port unit logical-unit-number],
Hierarchy Level
[edit logical-systems logical-system-name interfaces at-fpc/pic/port unit logical-unit-number]
Statement introduced in JUNOS Release 8.2.
Release Information
For GRE tunnel interfaces only, enable the inner IP header s TOS bits to be copied
Description
to the outer IP packet header.
If you omit this statement, the TOS bits in the outer IP header are set to 0.
Default
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
1040
control-signal
—The to-DCE signal must be asserted.
—The to-DCE signal must be deasserted.
—Normal request-to-send (RTS) signal handling, as defined by ITU-T
Recommendation X.21.
Default: normal
Configuring the Serial Signal Handling on page 278
JUNOS Class of Service Configuration Guide