Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 784

JUNOS 10.1 Network Interfaces Configuration Guide
NOTE: Associating an
CFM session running over a CCC interface (l2circuit/l2vpn) is not advisable and could
result in a deadlock situation.
Configuring a CFM Action Profile Event
You can configure one or more events under the action profile, the occurrence of
which will trigger the corresponding action to be taken.
To configure the interface-status-tlv lower-layer-down event, include the
interface-status-tlv lower-layer-down
connectivity-fault-management action-profile profile-name event]
To configure the interface-status-tlv down event, include the
statement at the
profile-name event]
To configure the port-status-tlv blocked event, include the
statement at the
profile-name event]
To configure the adjacency-loss event, include the
[edit protocols oam ethernet connectivity-fault-management action-profile profile-name
event]
714
Configuring a Connectivity Fault Management Action Profile
}
action-profile
[edit protocols oam ethernet connectivity-fault-management action-profile
hierarchy level.
[edit protocols oam ethernet connectivity-fault-management action-profile
hierarchy level.
hierarchy level.
[edit protocols oam]
ethernet {
connectivity-fault-management {
action-profile bring-down {
event {
interface-status-tlv [lower-layer-down down];
port-status-tlv blocked;
adjacency-loss;
}
action {
interface-down;
}
}
}
}
with the action of interface-down
statement at the
[edit protocols oam ethernet
port-status-tlv blocked
adjacency-loss
on an up MEP
hierarchy level.
interface-status-tlv down
statement at the