Configuring The Layer 2 Circuit Cell-Relay Cell Maximum - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Configuring the Layer 2 Circuit Cell-Relay Cell Maximum

By default, each frame contains one cell. For ATM interfaces with Layer 2 circuit
cell-relay transport mode configured, you can configure the maximum number of
ATM cells per frame on the physical or logical interface. To set the maximum number
of cells per frame, include the
You can include this statement at the following hierarchy levels:
The cell bundle size can be from 1 through 176.
After 125 microseconds, cell bundling times out. This means that after 125
microseconds if the frame does not contain the configured value, the frame is
transmitted anyway.
If you include the
atm-options]
the logical interface units configured for that physical interface. If you include the
cell-bundle-size
overrides the value configured at the physical interface level.
The transmit rates you configure on the routers at each end of the connection must
be the same value.
priority low;
transmit-weight percent 20;
}
forwarding-class nrtvbr-class {
priority low;
transmit-weight percent 30;
}
forwarding-class ubr-class {
priority low;
transmit-weight percent 40;
}
}
}
}
unit 0 {
trunk-id 0;
trunk-bandwidth 10m;
atm-scheduler-map cos0;
}
}
cell-bundle-size cells;
[edit interfaces interface-name atm-options]
[edit interfaces interface-name unit logical-unit-number]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number]
cell-bundle-size
hierarchy level, then the configured value becomes the default for all
statement for a logical interface, the logical interface configuration
Chapter 13: Configuring ATM Interfaces
statement:
cell-bundle-size
statement at the [edit interfaces interface-name
Configuring the Layer 2 Circuit Cell-Relay Cell Maximum
321