Managing Eth-Dm Statistics And Eth-Dm Frame Counts; Displaying Eth-Dm Statistics Only; Displaying Eth-Dm Statistics And Frame Counts; Displaying Eth-Dm Frame Counts For Meps By Enclosing Cfm Entity - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide
NOTE: If you attempt to monitor delays to a nonexistent MAC address, you must
type
return to the CLI command prompt.
Related Topics

Managing ETH-DM Statistics and ETH-DM Frame Counts

Displaying ETH-DM Statistics Only

Display ETH-DM statistics.
Purpose
By default, the
command displays ETH-DM statistics for MEPs in the specified CFM maintenance
association (MA) within the specified CFM maintenance domain (MD).
Action
758
Managing ETH-DM Statistics and ETH-DM Frame Counts
Ctrl + C to explicitly quit the
Ethernet Frame Delay Measurements Overview on page 739
Guidelines for Starting an ETH-DM Session on page 746
monitor ethernet delay-measurement
Guidelines for Managing ETH-DM Statistics and ETH-DM Frame Counts on page 748
Managing ETH-DM Statistics and ETH-DM Frame Counts on page 758
Displaying ETH-DM Statistics Only on page 758
Displaying ETH-DM Statistics and Frame Counts on page 759
Displaying ETH-DM Frame Counts for MEPs by Enclosing CFM Entity on page 759
Displaying ETH-DM Frame Counts for MEPs by Interface or Domain
Level on page 760
Clearing ETH-DM Statistics and Frame Counts on page 760
show oam ethernet connectivity-fault-management delay-statistics
To display the ETH-DM statistics collected for MEPs belonging to MA
within MD :
md1
user@host> show oam ethernet connectivity-fault-management delay-statistics
maintenance-domain ma1 maintenance-association ma1
To display the ETH-DM statistics collected for ETH-DM sessions for the local
MEP 201 belonging to MA
user@host> show oam ethernet connectivity-fault-management delay-statistics
maintenance-domain md2 maintenance-association ma2 local-mep 201
To display the ETH-DM statistics collected for ETH-DM sessions from local MEPs
belonging to MA and within MD
ma3
user@host> show oam ethernet connectivity-fault-management delay-statistics
maintenance-domain md3 maintenance-association ma3 remote-mep 302
monitor ethernet delay-measurement
command
ma2 and within MD md2 :
to remote MEP
md3
command and
ma1 and
:
302