Table 79: Capabilities Of 10-Port 10-Gigabit Ose Pics - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Table 79 on page 811 lists the capabilities of 10-Port 10-Gigabit OSE PICs.

Table 79: Capabilities of 10-Port 10-Gigabit OSE PICs

Configuring Line Rate Mode on 10-port 10-Gigabit Oversubscribed Ethernet PIC
The 10-port 10-Gigabit Oversubscribed Ethernet (OSE) PIC can be configured in the
command-line interface (CLI) to operate in the following two modes:
Chapter 52: Configuring 10-port 10-Gigabit Oversubscribed Ethernet PICs
Committed information rate and peak information rate configurations are not
supported at the physical interface level.
There is limited packet buffering of 2 MB.
Delay-bandwidth buffering configuration is not supported.
Multifield classifiers are not supported at the PIC level.
The multifield classification can be done at the Packet Forwarding Engine using
the firewall filters, which overrides the classification done at the PIC level. The
multifield classification at the Packet Forwarding Engine occurs after the PIC
handles the oversubscribed traffic.
Egress MAC policer statistics is not supported.
Byte counters are not supported at the queue level.
Only standard TPID (0x8100) is supported.
Line timing mode is not supported.
MAC level Rx VLAN tagged frames counter is not supported.
Capability
Maximum VLANs per PIC
Maximum VLANs per port
MAC learning per port
MAC accounting per port
MAC filtering per port
MAC policers
Classifers
Oversubscribed Ethernet Mode (default): In this mode, all the ten ports are
enabled on the PIC with two-to-one oversubscription.
Configuring Line Rate Mode on 10-port 10-Gigabit Oversubscribed Ethernet PIC
Support
4065
1022
960
960
960 (64 filters per physical or logical
interface)
960 filters across multiple logical interfaces
128 ingress Mac policers
128 egress Mac policers
Eight classifiers per PIC for each BA classifier
type
811