JUNOS 10.1 Network Interfaces Configuration Guide
Congestion Control
ATM encapsulations provide congestion control via EPD thresholds on a per logical
interface basis. For Circuit Emulation PICs, the EPD number specifies the number
of packets (or frames or cell bundles).
QoS/Shaping
Unspecified bit rate (UBR) is supported.
Configuring the PIC Type
To configure Circuit Emulation PICs, you must specify the
pic-type
Configuring Layer 2 Circuit and Layer 2 VPN Pseudowires
ATM Layer 2 circuit and Layer 2 VPN pseudowires are configured using the same
syntax described for ATM2 PICs:
Supported Interface Configurations
With 12-port Channelized T1/E1 Circuit Emulation PICs, ATM supports T1 and E1
interfaces:
A sample configuration follows:
556
Congestion Control
[edit interfaces at-fpc/pic/port unit logical-unit-number]
epd-threshold packets plp1 packets;
option as
atm-ce
, as follows:
[edit interfaces at-fpc/pic/port]
atm-options {
pic-type atm-ce;
}
protocols {
# MPLS and routing configuration omitted for brevity.
l2circuit {
neighbor 10.255.245.1 { # loopback address on remote router
interface at-0/0/0.0 { # Circuit Emulation PIC ATM interface configured for CCC
virtual-circuit-id 100;
}
}
}
}
[edit interfaces at-fpc/pic/port ]
t1-options
e1-options
at-0/2/1:3 {
statement
atm-options