Example E-Lmi Configuration; Configuring Pe1; Figure 65: E-Lmi Configuration For A Point-To-Point Evc (Svlan) Monitored - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

as the default EVC interface using the
ethernet lmi interface name evc evc-id]
to any other EVCs are mapped to this EVC. Only one EVC can be configured as the
default.
You can map a list of VLANs to an EVC using the
[edit protocols oam ethernet lmi interface name evc evc-id]

Example E-LMI Configuration

Figure 65 on page 719 illustrates the E-LMI configuration for a point-to-point EVC
(SVLAN) monitored by CFM. In this example, VLANs 1 through 2048 are mapped to
evc1
CFM sessions are created to monitor these EVCs.
Figure 65: E-LMI Configuration for a Point-to-Point EVC (SVLAN) Monitored by CFM
CE1
UNI-C E-LMI

Configuring PE1

Chapter 43: Configuring IEEE 802.1ag OAM Connectivity-Fault Management
(SVLAN 100) and 2049 through 4096 are mapped to
ge-1/1/2
PE1
ge-1/1/1
CFM sessions
CFM up MEP
UNI-N Ethernet Virtual Connections
[edit]
interfaces {
ge-1/1/1 {
unit 0 {
family bridge {
interface-mode trunk;
vlan-id-list 1-2048;
}
}
unit 1 {
family bridge {
interface-mode trunk;
vlan-id-list 2049-4096;
}
}
}
ge-1/1/2 {
unit 0 {
vlan-id 100;
family bridge {
interface-mode trunk;
inner-vlan-id-list 1-2048;
}
}
statement at the
default-evc
hierarchy level. All VIDs that are not mapped
vlan-list vlan-id-list
ge-2/2/1
PE2
ge-2/2/2
CFM up MEP
UNI-N E-LMI
Configuring Ethernet Local Management Interface
[edit protocols oam
statement at the
hierarchy level.
(SVLAN 200). Two
evc2
CE2
UNI-C
719