Invalid Eia-530 Interface Statements; Invalid V.35 Interface Statements; Invalid X.21 Interface Statements - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

You can include the line-protocol statement at the following hierarchy levels:
X.21 Interface Default Settings
If you include the
You can include the line-protocol statement at the following hierarchy levels:
Invalid Serial Interface Statements
The following sections show the invalid configuration statements for each type of
serial interface. If you include the following statements in the configuration, an error
message indicates the location of the error and the configuration is not activated.
dsr normal;
dtr normal;
rts normal;
}
clock-rate 16.384mhz;
clocking-mode loop;
cts-polarity positive;
dcd-polarity positive;
dsr-polarity positive;
dtr-circuit balanced;
dtr-polarity positive;
encoding nrz;
rts-polarity positive;
[edit interfaces se-pim/0/port serial-options]
[edit interfaces se-fpc/pic/port serial-options]
line-protocol x.21
dce-options | dte-options {
control-signal normal;
indication normal;
}
clock-rate 16.384mhz;
clocking-mode loop;
control-polarity positive;
encoding nrz;
indication-polarity positive;
[edit interfaces se-pim/0/port serial-options]
[edit interfaces se-fpc/pic/port serial-options]
Invalid EIA-530 Interface Statements on page 274
Invalid V.35 interface Statements on page 274
Invalid X.21 Interface Statements on page 274
Chapter 12: Configuring Serial Interfaces
statement, the default settings are as follows:
Configuring the Serial Line Protocol
273