Table 50: IMA Link Alarms with IMA Standard Requirement Numbers (continued)
Alarm
Tx-Unusable-FE
Rx-Unusable-FE
Link Fault
Table 51 on page 549 shows the supported IMA link defects and their associated IMA
standard requirement numbers.
Table 51: IMA Link Defects with IMA Standard Requirement Numbers
Defect
LIF
LODS
RFI-IMA
Tx-Mis-Connected
Rx-Mis-Connected
Tx-Unusable-FE
Rx-Unusable-FE
Link Fault
IMA Group Statistics
You can use the
statistics:
For more information about IMA group statistic, see the
description in the JUNOS Interfaces Command Reference.
IMA Standard Requirement
Number
R-143
R-144
IMA Standard Requirement
Number
R-138
R-139
R-140
R-141
R-142
R-143
R-144
show interfaces
Near-end failure count
Far-end failure count
Rx faulty cells due to address mismatch
Running seconds
Unavailable seconds
Chapter 28: Configuring ATM Support on Circuit Emulation PICs
Description
Transmit unusable far end
Receive unusable far end
Link fault
Description
Loss of IMA frame
Link out of delay synchronization
Remote defect/failure
Transmit misconnected
Receive misconnected
Transmit unusable far end
Receive unusable far end
Link fault
command to display the following IMA group
show interfaces
ATM IMA Configuration Overview
command
549