Ethernet-Switch-Profile - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

ethernet-switch-profile

ethernet-switch-profile {
Syntax
}
[edit interfaces interface-name gigether-options],
Hierarchy Level
[edit interfaces interface-name aggregated-ether-options]
Statement introduced before JUNOS Release 7.4.
Release Information
For Gigabit Ethernet IQ, 10-Gigabit Ethernet IQ2 and IQ2-E, and Gigabit Ethernet
Description
PICs with SFPs (except the 10-port Gigabit Ethernet PIC, aggregated Ethernet with
Gigabit Ethernet IQ interfaces, and the built-in Gigabit Ethernet port on the M7i
router), configure VLAN tag and MAC address accounting and filtering properties.
The statements are explained separately.
NOTE: When you gather interfaces into a bridge domain, the
statement at the [
hierarchy level is not supported. You must use the
[
hierarchy level to disable MAC learning on an interface in a bridge domain. For
ethernet-policer-profile {
input-priority-map {
ieee802.1p premium [ values ];
}
output-priority-map {
classifier {
premium {
forwarding-class class-name {
loss-priority (high | low);
}
}
}
}
policer cos-policer-name {
aggregate {
bandwidth-limit bps;
burst-size-limit bytes;
}
premium {
bandwidth-limit bps;
burst-size-limit bytes;
}
}
tag-protocol-id tpid;
}
(mac-learn-enable | no-mac-learn-enable);
edit interfaces interface-name gigether-options ethernet-switch-profile
edit bridge-domains bridge-domain-name bridge-options interface interface-name
Chapter 62: Summary of Interface Configuration Statements
no-mac-learning
ethernet-switch-profile
no-mac-learn-enable
]
statement at the
]
1115