Chapter 22
Configuring Channelized T3 Interfaces
Configuring Channelized T3 IQ Interfaces
Configuring T3 IQ Interfaces
Configuring Channelized T3 IQ Interfaces on page 489
Configuring Channelized DS3-to-DS0 Interfaces on page 492
Configuring Channelized DS3-to-DS1 Interfaces on page 495
Example: Configuring Channelized T3 IQ Interfaces on page 496
Examples: Configuring Channelized DS3-to-DS0 Interfaces on page 497
Examples: Configuring Channelized DS3-to-DS1 Interfaces on page 500
NOTE: Class-of-service (CoS) rules cannot be applied to an individual channel
configured on channelized IQ interfaces. You can only apply CoS rules to the aggregate
bit streams.
This section describes how to configure channelized T3 intelligent queuing (IQ)
interfaces, discussing the following topics:
Configuring T3 IQ Interfaces on page 489
Configuring T1 IQ Interfaces on page 490
Configuring Fractional T1 IQ and IQE Interfaces on page 490
Configuring an NxDS0 IQ Interface on page 491
To configure a T3 interface, include the no-partition and interface-type statements at
the [edit interfaces ct3-fpc/pic/port] hierarchy level:
[edit interfaces ct3-fpc/pic/port]
no-partition interface-type t3;
This configuration creates interface t3-fpc/pic/port .
Configuring Channelized T3 IQ Interfaces
489