Example: Configuring An Nxds0 Iq Or Iqe Interface; Configuring Channelized E1 Interfaces - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

For channelized E1 IQ and IQE interfaces, the partition number range is from 1
through 31.
For E1 IQ and IQE interfaces (
31. For channelized E1 IQ and IQE interfaces (
is from 1 through 31. You can designate any combination of time slots. To configure
ranges, use hyphens. To configure discontinuous time slots, use commas. Do not
include spaces. For more information about E1 time slots, see "Configuring Fractional
E1 Time Slots" on page 566.

Example: Configuring an NxDS0 IQ or IQE Interface

Configure an NxDS0 interface that uses time slots 2 through 10. This configuration
creates the
For a full configuration example, see the JUNOS Feature Guide.

Configuring Channelized E1 Interfaces

By default, all the time slots on a channelized E1 interface are used. There can be a
maximum of 24 channel groups per channelized E1 interface. Thus, you can configure
a maximum of 240 channel groups per PIC.
To specify the DS0 channel group number in the interface name, include a colon (:)
as a separator. For example, a Channelized E1 PIC might have the following physical
and virtual interfaces:
where
ranges, see Table 46 on page 514).
You can use any of the values within the range available for
configure the links sequentially. In addition, the JUNOS Software applies the interface
options you configure according to the following rules:
To configure the channel groups and time slots for a channelized E1 interface, include
the following statements at the
ds-0/0/0:1:1 interface.
[edit interfaces ce1-0/0/0:1]
partition 1 timeslots 2-10 interface-type ds;
ds-0/0/0:x
is a DS0 channel group from 0 through 23 (for more information about
x
To configure the e1-options
ds-0/0/0:0
There are no restrictions on configuring the
If you delete a configuration you previously committed for channel group 0, the
options return to default values.
[edit chassis]
fpc slot-number {
pic pic-number {
Chapter 24: Configuring Channelized E1 Interfaces
), the time-slot range is from 2 through
e1-fpc/pic/port
ce1-fpc/pic/port
statement, you must set channel group
ds0-options
hierarchy level:
[edit chassis]
Configuring Channelized E1 Interfaces
), the time-slot range
; you do not have to
x
to 0 :
x
statement.
513