Table of Contents
Advertisement
JUNOS 10.1 Network Interfaces Configuration Guide
For more information about E1 time slots, see "Configuring Fractional E1 Time Slots"
on page 566.
Example: Configuring Fractional E1 Interfaces
Configure a fractional E1 interface that uses time slots 2 through 10:
For a full configuration example, see the JUNOS Feature Guide.
Configuring an NxDS0 IQ Interface
By default, all the time slots on a channelized STM1 interface are used. To configure
an NxDS0 IQ interface on a Channelized STM1 IQ or IQE PIC, perform the following
tasks:
1.
2.
3.
476
Configuring Channelized STM1 IQ and IQE Interfaces
[edit interfaces cstm1-0/0/0]
no-partition cau4;
[edit interfaces cau4-0/0/0]
partition 1 interface-type e1;
[edit interfaces e1-0/0/0 e1-options]
timeslots 2-10;
Include the
no-partition
cstm1-fpc/pic/port]
hierarchy level, specifying the
converts the channelized STM1 interface into a channelized AU-4 interface. The
resulting interface name is
[edit interfaces cstm1-fpc/pic/port]
no-partition interface-type cau4;
Partition the channelized AU-4 interface into E1 interfaces by including the
and
partition
interface-type
hierarchy level, specifying the
interface
ce1-fpc/pic/port:channel
partition index and is correlated with the channel number. For channelized E1
interfaces, the partition number can be from 1 through 63. The interface type
is the channelized interface type or clear channel you are creating. For
channelized AU-4 interfaces,
[edit interfaces cau4-fpc/pic/port]
partition partition-number interface-type ce1;
Configure the number of time slots allocated to the NxDS0 IQ interface by
including the
partition
,
timeslots
interfaces e1-fpc/pic/port:channel]
type. For channelized E1 IQ interfaces, the partition number range is from
1 through 31. For E1 IQ interfaces (
2 through 31. For channelized E1 IQ interfaces (
range is from 1 through 31. You can designate any combination of time slots.
To configure ranges, use hyphens. To configure discontinuous time slots, use
commas. Do not include spaces:
[edit interfaces ce1-fpc/pic/port:channel]
partition partition-number timeslots time-slot-range interface-type ds;
and
statements at the
interface-type
:
cau4-fpc/pic/port
statements at the
[edit interfaces cau4-fpc/pic/port]
ce1
interface type. This configuration creates
. The partition number is the sublevel interface
can be
ce1
or
e1
type
, and
interface-type
hierarchy level, specifying the
e1-fpc/pic/port
ce1-fpc/pic/port
[edit interfaces
cau4
interface type. This
:
statements at the
[edit
interface
ds
), the time-slot range is from
), the time-slot
Advertisement
Table of Contents
