Table 34: Frame Relay Dlci Limitations For Channelized Interfaces - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide
Data-Link Connection Identifiers on Channelized Interfaces
If you use Frame Relay encapsulation on a channelized interface, see Table 34 on
page 396 for the maximum number of data-link connection identifiers (DLCIs) per
channel that you can configure at each channel level for various channelized PICs.
If you use a per-unit-scheduler configuration on a channelized interface, see Table
35 on page 397 for the maximum number of data-link connection identifiers (DLCIs)
per channel that you can configure at each channel level for various channelized
PICs.
NOTE: The actual number of DLCIs you can configure for each channel is determined
by the capabilities of your system, such as the number and types of PICs installed.
If the number of DLCIs in the configuration exceeds the capabilities of your system,
the router might not be able to support the maximum DLCI values shown in Table
34 on page 396. To determine the capabilities of your system, please contact Juniper
Networks customer support.

Table 34: Frame Relay DLCI Limitations for Channelized Interfaces

PIC Types
Original Channelized PICs
DS0 level channels
T3 and T1 level channels
Channelized IQ and IQE PICs
DS0 level channels (Channelized DS3 IQ or IQE, Channelized STM1
IQ or IQE, Channelized E1 IQ or IQE, Channelized OC3 IQ or IQE,
or Channelized OC12 IQ or IQE PICs)
E1 level channels (Channelized E1 IQ or IQE PIC)
396
Data-Link Connection Identifiers on Channelized Interfaces
on Channelized OC48 IQE, or one STM1 channel on a Channelized STM1 IQ or
IQE PICs.
—T1 channel. Configure on Channelized T1 IQ or IQE,
t1-fpc/pic/port:channel
Channelized OC3 IQ or IQE, Channelized OC12 IQ or IQE, Channelized OC48
IQE, or Channelized DS3 IQ or IQE PICs.
t3-fpc/pic/port:channel —T3 channel. Configure on Channelized OC3 IQ or IQE,
Channelized OC12 IQ or IQE, Channelized OC48 IQE, Clear Channel DS3E3 IQE,
or Channelized DS3 IQ or IQE PICs.
Number of DLCIs
per Level Range
3 for sparse 1–1022 for sparse mode (0 is
mode reserved for the Local Management
Interface [LMI])
63 for regular 1–63 for regular mode
mode
3 for sparse 1–1022 for sparse mode (0 is
mode reserved for the LMI)
16 1–1022 (0 is reserved for the LMI)
64 1–1022 (0 is reserved for the LMI)