Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 537

statements at the
interface-type
level, specifying the ct3
[edit interfaces coc1-fpc/pic/port:channel]
no-partition partition-number interface-type ct3;
NOTE: Class-of-service (CoS) rules cannot be applied to an individual channel
configured on channelized IQ interfaces. You can only apply CoS rules to the aggregate
bit streams.
Note that because the
not create another level of channelization, as denoted by the number of colons
in the resulting interface.
To configure T1 interfaces, partition the channelized T3 interface into T1
4.
interfaces by including the
interfaces ct3-fpc/pic/port:channel]
type:
[edit interfaces ct3-fpc/pic/port:channel]
partition partition-number interface-type t1;
To configure NxDS0 interfaces, partition the channelized T3 interface into
5.
channelized T1 interfaces by including the
at the
[edit interfaces ct3-fpc/pic/port:channel]
ct1 interface type:
[edit interfaces ct3-fpc/pic/port:channel]
partition partition-number interface-type ct1;
NOTE: Class-of-service (CoS) rules cannot be applied to an individual channel
configured on channelized IQ interfaces. You can only apply CoS rules to the aggregate
bit streams.
Figure 46 on page 468 shows VT-mapped and M13 or C-bit parity-mapped
configurations of T1 IQ interfaces.
Chapter 20: Configuring Channelized OC3 IQ and IQE Interfaces
[edit interfaces coc1-fpc/pic/port:channel]
interface type:
statement is included, this configuration does
no-partition
partition and interface-type
hierarchy level, specifying the
partition
hierarchy level and specifying the
Configuring T1 and NxDS0 Interfaces
hierarchy
statements at the [edit
interface
t1
and interface-type statements
467