Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 1088

JUNOS 10.1 Network Interfaces Configuration Guide
cbr
cbr rate;
Syntax
Hierarchy Level [edit interfaces at-fpc/pic/port atm-options vpi vpi-identifier shaping],
[edit interfaces at-fpc/pic/port unit logical-unit-number address address family family
multipoint-destination address shaping],
[edit interfaces at-fpc/pic/port unit logical-unit-number shaping],
[edit logical-systems logical-system-name interfaces at-fpc/pic/port unit logical-unit-number
[edit logical-systems logical-system-name interfaces at-fpc/pic/port unit logical-unit-number
Statement introduced before JUNOS Release 7.4.
Release Information
For ATM encapsulation only, define a constant bit rate bandwidth utilization in the
Description
traffic-shaping profile.
Unspecified bit rate (UBR); that is, bandwidth utilization is unlimited.
Default
rate
Options
For ATM1 OC3 interfaces, the maximum available rate is 100 percent of
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
1018
cbr
address address family family multipoint-destination address shaping],
shaping]
—Peak rate, in bits per second (bps) or cells per second (cps). You can specify a
value in bits per second either as a complete decimal number or as a decimal
number followed by the abbreviation
(1,000,000,000). You can also specify a value in cells per second by entering
g
a decimal number followed by the abbreviation
second are converted to bits per second by means of the formula
1 cps = 384 bps.
135,600,000 bps. For ATM1 OC12 interfaces, the maximum available rate is
50 percent of , or 271,263,396 bps. For ATM2 IQ interfaces, the maximum
line-rate
available rate is 542,526,792 bps.
Defining the ATM Traffic-Shaping Profile on page 326
rtvbr on page 1404
shaping on page 1424
vbr on page 1513
(1000), (1,000,000), or
k m
; values expressed in cells per
c
line-rate , or