Table 31: Atm-Over-Adsl Operational Modes - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Configuring the ATM-over-ADSL Virtual Path Identifier
Set the ATM virtual path identifier (VPI) to 0 (zero) by including the
at the
Configuring the ATM-over-ADSL Physical Interface Operating Mode
Configure the ADSL operating mode on the physical ATM interface by including the
operating-mode
level:
By default, the mode is
to match the setting of the DSLAM located at the central office.
Table 31 on page 365 shows the Annex A PIM and Annex B PIM operational modes
for ATM-over-ADSL interfaces.

Table 31: ATM-over-ADSL Operational Modes

Configuring the ATM-over-ADSL Protocol Family on page 367
Configuring the ATM-over-ADSL Virtual Channel Identifier on page 368
[edit interfaces at-pim/0/port atm-options]
[edit interfaces at-pim/0/port atm-options]
vpi 0;
statement at the
[edit interfaces at-pim/0/port dsl-options]
operating-mode (adsl2plus | ansi-dmt | auto | etsi | itu-annexb-non-ur2 | itu-annexb-ur2 |
itu-dmt | itu-dmt-bis);
auto
Encapsulation Types
Annex A PIMs
adsl2plus
ansi-dmt
auto
itu-dmt
itu-dmt-bis
itu-lite
itu-lite-bis
Chapter 14: Configuring ATM-over-ADSL Interfaces
hierarchy level:
[edit interfaces at-pim/0/port dsl-options]
, which means the ADSL line autonegotiates the setting
Comments
Set the ADSL line to train in the ITU G.992.5 mode.
Set the ADSL line to train in the ANSI T1.413 Issue 2
mode.
Set the ADSL line to autonegotiate the setting to match
the setting of the DSLAM located at the central office.
The ADSL line trains in the ANSI T1.413 Issue 2 (
or ITU G.992.1 (
itu-dmt
Set the ADSL line to train in the ITU G.992.1 mode.
Set the ADSL line to train in the ITU G.992.3 mode.
Set the ADSL line to train in the G.992.2 mode.
Set the ADSL line to train in the G.992.4 mode.
Configuring the ATM-over-ADSL Virtual Path Identifier
statement
vpi 0
hierarchy
ansi-dmt
) mode.
)
365