JUNOS 10.1 Network Interfaces Configuration Guide
Figure 76: APS/MSP Configuration Topologies
To configure APS or MSP, include the
interface-name sonet-options]
This section includes the following topics:
912
Configuring SONET/SDH Physical Interface Properties
[edit interfaces interface-name sonet-options]
aps {
advertise-interval milliseconds;
annex-b
authentication-key key;
force;
hold-time milliseconds;
lockout;
neighbor address;
paired-group group-name;
protect-circuit group-name;
request;
revert-time seconds;
switching-mode (bidirectional | unidirectional);
working-circuit group-name;
}
Configuring Basic APS Support on page 913
Configuring Container Interfaces on page 915
Configuring APS Using a Container Interface with ATM Encapsulation on page 918
Configuring Switching Between the Working and Protect Circuits on page 919
Configuring Revertive Mode on page 921
Configuring Unidirectional Switching Mode Support on page 922
Configuring APS Timers on page 923
Configuring Link PIC Redundancy on page 923
Example: Configuring Link PIC Redundancy on page 924
Configuring APS Load Sharing Between Circuit Pairs on page 924
Example: Configuring APS Load Sharing Between Circuit Pairs on page 927
aps
statement at the
hierarchy level:
[edit interfaces