Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 363

To configure ATM2 IQ logical interface properties, include the following statements:
ATM2 IQ Logical
Configuration Hierarchy
authentication-key key;
force;
hold-time milliseconds;
lockout;
neighbor address;
paired-group group-name;
protect-circuit group-name;
request;
revert-time seconds;
working-circuit group-name;
}
bytes {
e1-quiet value;
f1 value;
f2 value;
s1 value;
z3 value;
z4 value;
}
loopback (local | remote);
(payload-scrambler | no-payload-scrambler);
rfc-2615;
trigger {
defect ignore {
hold-time up milliseconds down milliseconds;
}
}
(z0-increment | no-z0-increment);
}
allow-any-vci;
atm-scheduler-map (map-name | default);
cell-bundle-size cells;
epd-threshold cells;
multicast-vci vpi-identifier.vci-identifier;
oam-liveness {
up-count cells;
down-count cells;
}
oam-period (disable | seconds);
plp-to-clp;
shaping {
(cbr rate | rtvbr peak rate sustained rate burst length | vbr peak rate sustained rate
burst length);
}
transmit-weight number;
trunk-id number;
vci vpi-identifier.vci-identifier;
vpi vpi-identifier;
family inet address address {
multipoint-destination address;
epd-threshold cells;
inverse-arp;
ATM2 IQ Physical and Logical Configuration Statement Hierarchies
Chapter 13: Configuring ATM Interfaces
293