Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 947

deactivation-delay seconds;
dial-string dial-string-numbers;
idle-timeout seconds;
incoming-map {
caller (caller-id | accept-all);
initial-route-check seconds;
load-interval seconds;
load-threshold percent;
pool pool-name;
redial-delay time;
watch-list {
[ routes ];
}
}
}
}
You can configure the following options:
—ISDN activation delay, in seconds. Specify a number from
activation-delay
through
4294967295
—Configure the dialer to terminate the incoming call and call back the
callback
originator after the callback wait period.
callback-wait-period —For interfaces configured for ISDN with callback, specify
the amount of time the dialer waits before calling back the caller. The default is
5 seconds.
—Specify the dialer to accept a specified caller number or accept all
caller
incoming calls.
deactivation-delay —ISDN deactivation delay, in seconds. Specify from
.
4294967295
encapsulation —Logical link-layer encapsulation type. For normal mode, specify
for Cisco-compatible High-Level Data Link control (HDLC) or
cisco-hdlc
Point-to-Point Protocol. For multilink mode, specify
—Phone number to be dialed. Do not include hyphens in number.
dial-string
idle-timeout —Number of seconds the link is idle before losing connectivity. The
default is 120 seconds.
incoming-map —Specify the dialer to accept incoming calls. This statement is
required at one end of the ISDN connection.
CAUTION: Changing the caller incoming map when a call is connected can create
inconsistencies in the route and prevent traffic on a subnet from being transmitted.
This is seen when two dialer interfaces are configured and the association of the
caller incoming-map from one interface to the other is changed when a call is
connected on one of the interfaces. The cause of the inconsistency is that dialer
interfaces are pseudo interfaces that are always up, even if not actually connected.
—Allows the router to check whether the primary route is up
initial-route-check
after the initial startup of the router is complete and the timer expires.
Chapter 60: Configuring ISDN Interfaces
.
Configuring ISDN Logical Interface Properties
1
1 through
for
ppp
multilink-ppp .
877